by
Why ARQO
Tools
ARQOPush
Pricing
Docs
Downloads
Support
PluginsForAEC
Get early access
Tools · Clean up
Find Gap
Find gaps and open edge ends and mark them; Connect / Heal closes them.
1
2
3
How to use it
Select the edges to check, for example a plan outline that will not make a face.
Click Find Gap (toolbar, or Extensions › ARQO for SketchUp › DOCTOR).
Look at the marks: each gap is drawn with a ring at its middle, and the edges at the open ends become the selection.
Read the message: gaps found and the smallest, gaps over the limit, and ends with no other end near.
Run Connect/Heal to close the gaps, or raise the gap limit in Extensions › ARQO for SketchUp › Settings › Find Gap…
Good to know
Gap limit: 25 mm by default. Ends are paired nearest first, each end once, the same rule Connect/Heal uses.
Only gaps between two open ends count; an end that stops near a junction or an edge is not a gap.
Nothing is written to the model and there is no Undo step; the marks go away when the selection or the model changes.
With no open end found, your selection stays as it was.
Closed groups and components are not entered; ends in different contexts are not paired.
Always
One Undo takes the whole action back.
Shared components: you choose this copy or all copies.
The result is told in plain words; a refusal changes nothing.